ZIBOOZB-L100K Handheld LCR Test Clip Universal Digital Bridge Kelvin Test Line SMD Chip use for DE-5000 LCR Meter

Not too much to say about this other than it's well made and works with my LCR multi-meter. Connector not terribly long so you have to position the work piece somewhat close, but you'd want to do that anyway. The clips feel good in the hand and have sufficient spring force to hold securely. All-in-all I'm happy with these and don't have any problem recommending them to anyone looking for a decent set of Kelvin clips.

Works great, a little flimsy, but for the price it's decent. I wish the cable was a bit longer.

I found it to be well made, true Kelvin clips. The part that plugs into the LCR meter has two sides to each tong that are insulated in the middle of each tong, and appropriately wired to the clips. Works perfectly with my ZOYI ZT-DQ02 so indeed will also work with the ZT-DQ01. I can easily recommend this product 👍

Love it be sure to calibrate each time you change leads

Well. It does not fit the de-5000 out of the box.If you force it to plug in you WILL bend the tab clasps and the unit will not work any longer.If you look at the edges of the connectors that came with the unit. The edges have been filed to a point. To insert between the connectors. You must file the edges similarly on the new units. They will work fine. Note. The direction it is plugged in matters. The cable should be to the left.

As others have mentioned, this needs a little bit of work before it will fit well into a DE – 5000 LCR meter. You will need to bevel the blades and round off the edges a bit before inserting it into your meter. I used a piece of 220 grit sandpaper on a flat surface and carefully created a bevel. Then smoothed out the corners. Inserts easily now and is working well.

I bought a DE-5000 ESR tester on amazon resale for a discount. But came with no acceseries.So I purchased these so I could use my DE-5000. I did read about fileing the edges down so they would slide in easier.So I did and I think it helped.For the price I am happy with them.I have only used them three times so far and I am dieing to get back to use them. My schedule has been so jacked up that I have not had the free time to do so. I am thinking about using some vacation time to dive into my DE-5000.

This does not work with the DE5000 - at least not the one I was sent. It took me about an hour of debugging…(1) the contacts are too long and too wide(2) on the PCB, one of the measurement wire is bridged to the cable shield. Looks intentional, but you never know…in any event, cutting this connection makes think work with the DE5000.Problems (1) and (2) can be solved in a single session with a dremel and a cutoff wheel (if you shorten the contacts, you should grind the bottom to give it knife-like edge, as mentioned in other reviews)